Prevent warping in your 3D print.
With a heatbed you can easily print on it without making your print warp by cooling it too quickly.
This heatbed is 214x214mm and has a print surface of 200x200mm and has 2 sides, a side that gets warm when current flows through, the other is a copper layer that spreads the heat. In the middle of the bed there is a hole for a thermistor. You can easily place a glass bed on the heat bed using, for example, clamps.
The board has 2 connections a 12V and a 24V itself can draw the board 10A current. The resistance of the board is 1.2 to 2 Ohm.
At 12V the bed heats up to 90 ̊C in about 8 minutes.
At 24V the bed heats up to 120 ̊C in about 6 minutes.
You can easily connect an LED to the board for an indication of power.
De waardering van www.hestay.nl bij Webwinkel Keurmerk Klantbeoordelingen is 9.5/10 gebaseerd op 120 reviews.